Toro INFINITY 34/54 User Manual

1Toro’s new INFINITY Series sprinklers with SMART ACCESS™ are designed specically for Golf applications and extend and enhance Toro’s industry lead

10To Replace the Pilot Valve Solenoid ere are two Step 1s, depending on which version of the INFINITY Series sprinkler is being serviced.1With Intel

11To Remove the Sprinkler Riser Assembly1Insert the multipurpose tool into slot of riser cap. Tilt tool back to lock it in.2Pull up riser and grasp 

12For INF34 and INF54 Sprinklers (Full Circle only)Refer to Figure 8 for the following procedure.1. Grasp return spring (14) and riser (16) rmly and

13To Install the INF35 and INF55 Sprinkler Riser Assemblies1Insert the “hold up” tool into nozzle notch and riser spring collar.2Note locations of ali

14To Service the Main Valve and Rock Screen! WARNING: To service the main valve, the water supply to sprinkler must be shut o and any residual water

15To Reinstall Main ValveUse the valve insertion tool. ere are two sizes of the tool depending on the size of the sprinkler inlet. • 118-1843 is the

16Flushing the Sprinkler1. With sprinkler operating, carefully step down on center of cap several times. Water will ow around riser and ush out deb

2ACME read Notes e ACME thread golf sprinkler body requires an ACME thread swing joint for connection to the piping system. e ACME swing joint has

3Unpacking the Sprinkler1Remove the retaining screw.2Lift the cover.3Remove accessory kit.Waterproof Wire Splices! CAUTION: All wire splices and eld

4Sprinkler Wiring ConnectionsConnecting Communication Cable to the INFINITY Series with GDC Modulee GDC system provides a coded DC signal over a pola

5Connecting Control Wires to the INFINITY Series with Satellitee eld satellite controllers provide a 24 VAC signal to the sprinklers typically using

6Table 1: Recommended System Fill RatePipe Size Flow Velocity Pipe Size Flow Velocityinch cm GPM LPM ft/sec m/sec inch cm GPM LPM ft/sec m/sec1/2 1.3

7Servicee INFINITY Series sprinklers are designed to provide the user trouble-free operation for many years without scheduled maintenance. If it beco

8To Service the GDC Modulee GDC module has wires running directly to the solenoid. Replacement requires cutting and splicing wires. Use water-proof

9To Service the Pilot Valvee pilot valve can be replaced while the system is under pressure. Remove the pilot valve for service. Refer to Figure 1 f