Toro CCR 3650 GTS Snowthrower 38517 User Manual

Form No. 3355-426 Rev ACCR™ 3650 GTS® SnowthrowerModel No. 38517 —Serial No. 270000001 and UpOperator's ManualIntroductionR ead this infor mation

Stopping the EngineT o stop the engine , tur n the ignition k ey countercloc kwiseto the Off position ( Figure 17 ).Figure 17Starting the Rotor Blades

• Ov erlap eac h sw ath to ensure complete sno w remo v al.• Disc harg e the sno w do wnwind whenev er possible .• In sno wy and cold conditions , som

Figure 231. Z-tting 2. Adjuster linkNote: Mo ving the Z-fitting higher decreases the g apbetw een the control bar and the handle; mo ving it lo w erin

Folding the Handle1. Loosen the knobs and pull out the handle bolts .2. F old the upper handle forw ard ( Figure 25 ).Figure 2513

Snow CommanderandPower CurveSingle-stageSnow ProductsThe Toro 5-Year GTS Starting Guarantee andThe Toro 2-Year Total Coverage GuaranteeA Full Warranty

• K ee p the area of operation clear of all persons ,par ticularly small c hildren.• Ex ercise caution to a v oid slipping or falling, especiallywhen

Clearing a Clogged DischargeChuteHand contact with the rotating rotor blades inside thedisc harg e c hute is the most common cause of injur yassociate

Safety and Instructional DecalsImportant: Safety and instr uction decals ar e located near ar eas of potential danger . R eplace dama ged decals.105-1

60-9480104-2767104-2775104-41355

SetupLoose PartsUse the chart below to verify that all parts have been shipped.StepDescriptionQty.UseHandle bolt1Curved washer11.Knob1Install the hand

2. Installing the DischargeChuteInstall the disc harg e c hute as sho wn ( Figure 7 ).Figure 73. Installing the Chute Crank1. Inser t the end of the c

Product OverviewFigure 91. Discharge chute 6. Knob2. Chute crank7. Handle bolt (2)3. Control bar 8. Rotor blades4. Handle 9. Fuel tank cap5. Control p

4. Shak e the container to mix the g asoline and oilthoroughly .5. Slo wly remo v e the cap and add the remaining amountof g asoline .Note: Do not mix